linux/drivers/usb/musb/Makefile
Felipe Balbi 622859634a usb: musb: drop a gigantic amount of ifdeferry
the MUSB IP is always OTG, so there's no point
in adding so many ifdefs on the code. Drop those
and always compile the driver for OTG support.

This also allows us to drop the useless "driver
mode" choice. For doing that, we need to make
musb depend on both Host and Peripheral side.

Signed-off-by: Felipe Balbi <balbi@ti.com>
Signed-off-by: Greg Kroah-Hartman <gregkh@suse.de>
2011-07-01 14:31:10 -07:00

48 lines
1.2 KiB
Makefile

#
# for USB OTG silicon based on Mentor Graphics INVENTRA designs
#
obj-$(CONFIG_USB_MUSB_HDRC) += musb_hdrc.o
musb_hdrc-y := musb_core.o
musb_hdrc-y += musb_gadget_ep0.o musb_gadget.o
musb_hdrc-y += musb_virthub.o musb_host.o
musb_hdrc-$(CONFIG_DEBUG_FS) += musb_debugfs.o
# Hardware Glue Layer
obj-$(CONFIG_USB_MUSB_OMAP2PLUS) += omap2430.o
obj-$(CONFIG_USB_MUSB_AM35X) += am35x.o
obj-$(CONFIG_USB_MUSB_TUSB6010) += tusb6010.o
obj-$(CONFIG_USB_MUSB_DAVINCI) += davinci.o
obj-$(CONFIG_USB_MUSB_DA8XX) += da8xx.o
obj-$(CONFIG_USB_MUSB_BLACKFIN) += blackfin.o
obj-$(CONFIG_USB_MUSB_UX500) += ux500.o
# the kconfig must guarantee that only one of the
# possible I/O schemes will be enabled at a time ...
# PIO only, or DMA (several potential schemes).
# though PIO is always there to back up DMA, and for ep0
ifneq ($(CONFIG_MUSB_PIO_ONLY),y)
ifeq ($(CONFIG_USB_INVENTRA_DMA),y)
musb_hdrc-y += musbhsdma.o
else
ifeq ($(CONFIG_USB_TI_CPPI_DMA),y)
musb_hdrc-y += cppi_dma.o
else
ifeq ($(CONFIG_USB_TUSB_OMAP_DMA),y)
musb_hdrc-y += tusb6010_omap.o
else
ifeq ($(CONFIG_USB_UX500_DMA),y)
musb_hdrc-y += ux500_dma.o
endif
endif
endif
endif
endif