Merge reason: This branch was on an -rc5 base so pull almost-2.6.30
to resync with the latest upstream fixes and make sure
the combination works fine.
Signed-off-by: Ingo Molnar <mingo@elte.hu>
The current code to set up the GART as an IOMMU enables GART
translations before it removes the aperture from the kernel memory
map, sets the GART PTEs to UC, sets up the guard and scratch
pages, or does a wbinvd(). This leaves the possibility of cache
aliasing open and can cause system crashes.
Re-order the code so as to enable the GART translations only
after all safeguards are in place and the tlb has been flushed.
AMD has tested this patch on both Istanbul systems and 1st
generation Opteron systems with APG enabled and seen no adverse
effects. Istanbul systems with HT Assist enabled sometimes
see MCE errors due to cache artifacts with the unmodified
code.
Signed-off-by: Mark Langsdorf <mark.langsdorf@amd.com>
Cc: <stable@kernel.org>
Cc: Joerg Roedel <joerg.roedel@amd.com>
Cc: akpm@linux-foundation.org
Cc: jbarnes@virtuousgeek.org
Signed-off-by: Ingo Molnar <mingo@elte.hu>
We don't set up the canary; let's disable stack protector on boot.c so
we can get into lguest_init, then set it up. As a side effect,
switch_to_new_gdt() sets up %fs for us properly too.
Signed-off-by: Rusty Russell <rusty@rustcorp.com.au>
Acked-by: Tejun Heo <tj@kernel.org>
Signed-off-by: Linus Torvalds <torvalds@linux-foundation.org>
* master.kernel.org:/home/rmk/linux-2.6-arm:
[ARM] update mach-types
[ARM] Add cmpxchg support for ARMv6+ systems (v5)
[ARM] barriers: improve xchg, bitops and atomic SMP barriers
Gemini: Fix SRAM/ROM location after memory swap
MAINTAINER: Add F: entries for Gemini and FA526
[ARM] disable NX support for OABI-supporting kernels
[ARM] add coherent DMA mask for mv643xx_eth
[ARM] pxa/palm: fix PalmLD/T5/TX AC97 MFP
[ARM] pxa: add parameter to clksrc_read() for pxa168/910
[ARM] pxa: fix the incorrectly defined drive strength macros for pxa{168,910}
[ARM] Orion: Remove explicit name for platform device resources
[ARM] Kirkwood: Correct MPP for SATA activity/presence LEDs of QNAP TS-119/TS-219.
[ARM] pxa/ezx: fix pin configuration for low power mode
[ARM] pxa/spitz: provide spitz_ohci_exit() that unregisters USB_HOST GPIO
[ARM] pxa: enable GPIO receivers after configuring pins
[ARM] pxa: allow gpio_reset drive high during normal work
[ARM] pxa: save/restore PGSR on suspend/resume.
Addresses http://bugzilla.kernel.org/show_bug.cgi?id=13302
On x86 and x86-64, it is possible that page tables are shared beween
shared mappings backed by hugetlbfs. As part of this,
page_table_shareable() checks a pair of vma->vm_flags and they must match
if they are to be shared. All VMA flags are taken into account, including
VM_LOCKED.
The problem is that VM_LOCKED is cleared on fork(). When a process with a
shared memory segment forks() to exec() a helper, there will be shared
VMAs with different flags. The impact is that the shared segment is
sometimes considered shareable and other times not, depending on what
process is checking.
What happens is that the segment page tables are being shared but the
count is inaccurate depending on the ordering of events. As the page
tables are freed with put_page(), bad pmd's are found when some of the
children exit. The hugepage counters also get corrupted and the Total and
Free count will no longer match even when all the hugepage-backed regions
are freed. This requires a reboot of the machine to "fix".
This patch addresses the problem by comparing all flags except VM_LOCKED
when deciding if pagetables should be shared or not for hugetlbfs-backed
mapping.
Signed-off-by: Mel Gorman <mel@csn.ul.ie>
Acked-by: Hugh Dickins <hugh.dickins@tiscali.co.uk>
Cc: Ingo Molnar <mingo@elte.hu>
Cc: <stable@kernel.org>
Cc: Lee Schermerhorn <Lee.Schermerhorn@hp.com>
Cc: KOSAKI Motohiro <kosaki.motohiro@jp.fujitsu.com>
Cc: <starlight@binnacle.cx>
Cc: Eric B Munson <ebmunson@us.ibm.com>
Cc: Adam Litke <agl@us.ibm.com>
Cc: Andy Whitcroft <apw@canonical.com>
Signed-off-by: Andrew Morton <akpm@linux-foundation.org>
Signed-off-by: Linus Torvalds <torvalds@linux-foundation.org>
The flat loader uses an architecture's flat_stack_align() to align the
stack but assumes word-alignment is enough for the data sections.
However, on the Xtensa S6000 we have registers up to 128bit width
which can be used from userspace and therefor need userspace stack and
data-section alignment of at least this size.
This patch drops flat_stack_align() and uses the same alignment that
is required for slab caches, ARCH_SLAB_MINALIGN, or wordsize if it's
not defined by the architecture.
It also fixes m32r which was obviously kaput, aligning an
uninitialized stack entry instead of the stack pointer.
[akpm@linux-foundation.org: coding-style fixes]
Signed-off-by: Oskar Schirmer <os@emlix.com>
Cc: David Howells <dhowells@redhat.com>
Cc: Russell King <rmk@arm.linux.org.uk>
Cc: Bryan Wu <cooloney@kernel.org>
Cc: Geert Uytterhoeven <geert@linux-m68k.org>
Acked-by: Paul Mundt <lethal@linux-sh.org>
Cc: Greg Ungerer <gerg@uclinux.org>
Signed-off-by: Johannes Weiner <jw@emlix.com>
Acked-by: Mike Frysinger <vapier.adi@gmail.com>
Signed-off-by: Andrew Morton <akpm@linux-foundation.org>
Signed-off-by: Linus Torvalds <torvalds@linux-foundation.org>
Add cmpxchg/cmpxchg64 support for ARMv6K and ARMv7 systems
(original patch from Catalin Marinas <catalin.marinas@arm.com>)
The cmpxchg and cmpxchg64 functions can be implemented using the
LDREX*/STREX* instructions. Since operand lengths other than 32bit are
required, the full implementations are only available if the ARMv6K
extensions are present (for the LDREXB, LDREXH and LDREXD instructions).
For ARMv6, only 32-bits cmpxchg is available.
Mathieu :
Make cmpxchg_local always available with best implementation for all type sizes (1, 2, 4 bytes).
Make cmpxchg64_local always available.
Use "Ir" constraint for "old" operand, like atomic.h atomic_cmpxchg does.
Change since v3 :
- Add "memory" clobbers (thanks to Nicolas Pitre)
- removed __asmeq(), only needed for old compilers, very unlikely on ARMv6+.
Note : ARMv7-M should eventually be ifdefed-out of cmpxchg64. But it's not
supported by the Linux kernel currently.
Put back arm < v6 cmpxchg support.
Signed-off-by: Mathieu Desnoyers <mathieu.desnoyers@polymtl.ca>
CC: Catalin Marinas <catalin.marinas@arm.com>
CC: Nicolas Pitre <nico@cam.org>
Signed-off-by: Russell King <rmk+kernel@arm.linux.org.uk>
Mathieu Desnoyers pointed out that the ARM barriers were lacking:
- cmpxchg, xchg and atomic add return need memory barriers on
architectures which can reorder the relative order in which memory
read/writes can be seen between CPUs, which seems to include recent
ARM architectures. Those barriers are currently missing on ARM.
- test_and_xxx_bit were missing SMP barriers.
So put these barriers in. Provide separate atomic_add/atomic_sub
operations which do not require barriers.
Reported-Reviewed-and-Acked-by: Mathieu Desnoyers <mathieu.desnoyers@polymtl.ca>
Signed-off-by: Russell King <rmk+kernel@arm.linux.org.uk>
This will test the automatic aperture enlargement code. This is
important because only very few devices will ever trigger this code
path. So force it under CONFIG_IOMMU_STRESS.
Signed-off-by: Joerg Roedel <joerg.roedel@amd.com>
Disabling the round-robin allocator results in reusing the same
dma-addresses again very fast. This is a good test if the iotlb flushing
is working correctly.
Signed-off-by: Joerg Roedel <joerg.roedel@amd.com>
This patch makes sure no reserved addresses are allocated in an dma_ops
domain when the aperture is increased dynamically.
Signed-off-by: Joerg Roedel <joerg.roedel@amd.com>
Simplify the code a little bit by using the same unit for all address
space related state in the dma_ops domain structure.
Signed-off-by: Joerg Roedel <joerg.roedel@amd.com>
This patch changes the AMD IOMMU address allocator to allow up to 32
aperture ranges per dma_ops domain.
Signed-off-by: Joerg Roedel <joerg.roedel@amd.com>
The code will be required when the aperture size increases dynamically
in the extended address allocator.
Signed-off-by: Joerg Roedel <joerg.roedel@amd.com>
This patch makes sure that no function required for suspend/resume of
AMD IOMMU driver is thrown away after boot.
Signed-off-by: Joerg Roedel <joerg.roedel@amd.com>
Current hardware uses msi instead of msi-x so this code it not necessary
and can not be tested. The best thing is to drop this code.
Signed-off-by: Joerg Roedel <joerg.roedel@amd.com>
This patch restructures the AMD IOMMU initialization code to initialize
all hardware registers with one single function call.
This is helpful for suspend/resume support.
Signed-off-by: Joerg Roedel <joerg.roedel@amd.com>
This patch introduces the for_each_iommu and for_each_iommu_safe macros
to simplify the developers life when having to iterate over all AMD
IOMMUs in the system.
Signed-off-by: Joerg Roedel <joerg.roedel@amd.com>
Some drivers may use the dma api during ->remove which will
cause a protection domain to get reattached to a device. Delay the
detach until after the driver is completely unbound.
[ joro: added a little merge helper ]
[ Impact: fix too early device<->domain removal ]
Signed-off-by: Chris Wright <chrisw@redhat.com>
Signed-off-by: Joerg Roedel <joerg.roedel@amd.com>
The bug never triggered. But it should be fixed to protect against
broken ACPI tables in the future.
[ Impact: protect against broken ivrs acpi table ]
Signed-off-by: Joerg Roedel <joerg.roedel@amd.com>
The devid parameter to set_dev_entry_from_acpi is the requester ID
rather than the device ID since it is used to index the IOMMU device
table. The handling of IVHD_DEV_ALIAS used to pass the device ID.
This patch fixes it to pass the requester ID.
[ Impact: fix setting the wrong req-id in acpi-table parsing ]
Signed-off-by: Neil Turton <nturton@solarflare.com>
Signed-off-by: Joerg Roedel <joerg.roedel@amd.com>
The variable amd_iommu_last_bdf holds the maximum bdf of any device
controlled by an IOMMU, so the number of device entries needed is
amd_iommu_last_bdf+1. The function tbl_size used amd_iommu_last_bdf
instead. This would be a problem if the last device were a large
enough power of 2.
[ Impact: fix amd_iommu_last_bdf off-by-one error ]
Signed-off-by: Neil Turton <nturton@solarflare.com>
Signed-off-by: Joerg Roedel <joerg.roedel@amd.com>
This Kconfig option is intended to enable various code paths or
parameters in IOMMU implementations to stress test the code and/or the
hardware. This can also be done by disabling optimizations in the code
when this option is switched on.
Signed-off-by: Joerg Roedel <joerg.roedel@amd.com>
Cc: David Woodhouse <dwmw2@infradead.org>
Cc: FUJITA Tomonori <fujita.tomonori@lab.ntt.co.jp>
Add information about device memory mapping requirements for the IOMMU
as described in the IVRS ACPI table to the kernel log if amd_iommu_dump
was specified on the kernel command line.
Signed-off-by: Joerg Roedel <joerg.roedel@amd.com>
Add information about devices belonging to an IOMMU as described in the
IVRS ACPI table to the kernel log if amd_iommu_dump was specified on the
kernel command line.
Signed-off-by: Joerg Roedel <joerg.roedel@amd.com>
Add information about IOMMU devices described in the IVRS ACPI table to
the kernel log if amd_iommu_dump was specified on the kernel command
line.
Signed-off-by: Joerg Roedel <joerg.roedel@amd.com>
This kernel parameter will be useful to get some AMD IOMMU related
information in dmesg that is not necessary for the default user but may
be helpful in debug situations.
Signed-off-by: Joerg Roedel <joerg.roedel@amd.com>
