Because the VIA SuperIO chip only decodes 24 bits of address space but port
address space currently being configured as 32MB there is the theoretical
possibility of aliases within the I/O port address range.
The complicated solution is to reserve all address range that potencially
could cause such aliases. But with the PCI spec limiting port allocations
for devices to a maximum of 256 bytes 16MB of port address space already is
way more than one would ever expect to be used so we just reduce the port
space to 16MB.
Signed-off-by: Ralf Baechle <ralf@linux-mips.org>
To: Yoichi Yuasa <yuasa@linux-mips.org>
Cc: Bjorn Helgaas <bjorn.helgaas@hp.com>
Cc: linux-mips@linux-mips.org
Cc: Benjamin Herrenschmidt <benh@kernel.crashing.org>
Patchwork: http://patchwork.linux-mips.org/patch/995/
ALIGN(x, bytes) expands to __ALIGN_MASK(x, bytes - 1), so use the one
that is most clear.
Signed-off-by: Matt Turner <mattst88@gmail.com>
To: linux-mips@linux-mips.org
Cc: David Daney <ddaney@caviumnetworks.com>
Patchwork: http://patchwork.linux-mips.org/patch/999/
Signed-off-by: Ralf Baechle <ralf@linux-mips.org>
This is just a test program for raw_spinlocks. The main reason I
wrote it is to validate my spinlock changes that I sent in a previous
patch.
To use it enable CONFIG_DEBUG_FS and CONFIG_SPINLOCK_TEST then at run
time do:
# mount -t debugfs none /sys/kernel/debug/
# cat /sys/kernel/debug/mips/spin_single
# cat /sys/kernel/debug/mips/spin_multi
On my 600MHz octeon cn5860 (16 CPUs) I get
spin_single spin_multi
base 106885 247941
spinlock_patch 75194 219465
This shows that for uncontended locks the spinlock patch gives 41%
improvement and for contended locks 12% improvement (1/time).
Signed-off-by: David Daney <ddaney@caviumnetworks.com>
To: linux-mips@linux-mips.org
Patchwork: http://patchwork.linux-mips.org/patch/969/
Signed-off-by: Ralf Baechle <ralf@linux-mips.org>
The current locking mechanism uses a ll/sc sequence to release a
spinlock. This is slower than a wmb() followed by a store to unlock.
The branching forward to .subsection 2 on sc failure slows down the
contended case. So we get rid of that part too.
Since we are now working on naturally aligned u16 values, we can get
rid of a masking operation as the LHU already does the right thing.
The ANDI are reversed for better scheduling on multi-issue CPUs
On a 12 CPU 750MHz Octeon cn5750 this patch improves ipv4 UDP packet
forwarding rates from 3.58*10^6 PPS to 3.99*10^6 PPS, or about 11%.
Signed-off-by: David Daney <ddaney@caviumnetworks.com>
To: linux-mips@linux-mips.org
Patchwork: http://patchwork.linux-mips.org/patch/937/
Signed-off-by: Ralf Baechle <ralf@linux-mips.org>
Save/restore CPLD registers when doing suspend-to-ram; this fixes issues
with harddisk and ethernet not working correctly when resuming on DB1200.
Signed-off-by: Manuel Lauss <manuel.lauss@gmail.com>
To: Linux-MIPS <linux-mips@linux-mips.org>
Patchwork: http://patchwork.linux-mips.org/patch/986/
Signed-off-by: Ralf Baechle <ralf@linux-mips.org>
Change to different macros for assembler macros since the old names in
powertv_setup.c were co-opted for use in asm/asm.h. This broken the
build for the powertv platform. This patch introduces new macros based on
the new macros in asm.h to take the place of the old macro values.
Signed-off-by: David VomLehn <dvomlehn@cisco.com>
Cc: linux-mips@linux-mips.org
Patchwork: http://patchwork.linux-mips.org/patch/985/
Signed-off-by: Ralf Baechle <ralf@linux-mips.org>
The sole user is au1xxx_calc_clock() which is only used in early bootup
where the is no paralellism thus no race condition to protect against.
Signed-off-by: Ralf Baechle <ralf@linux-mips.org>
Cc: Manuel Lauss <manuel.lauss@googlemail.com>
If we wait for the once-per-second cleanup to free transmit SKBs,
sockets with small transmit buffer sizes might spend most of their
time blocked waiting for the cleanup.
Normally we do a cleanup for each transmitted packet. We add a
watchdog type timer so that we also schedule a timeout for 150uS after
a packet is transmitted. The watchdog is reset for each transmitted
packet, so for high packet rates, it never expires. At these high
rates, the cleanups are done for each packet so the extra watchdog
initiated cleanups are neither needed nor triggered.
Signed-off-by: David Daney <ddaney@caviumnetworks.com>
To: linux-mips@linux-mips.org
To: netdev@vger.kernel.org
To: gregkh@suse.de
Cc: Eric Dumazet <eric.dumazet@gmail.com>
Patchwork: http://patchwork.linux-mips.org/patch/968/
Signed-off-by: Ralf Baechle <ralf@linux-mips.org>
This version has spelling and comment changes based on feedback from
Eric Dumazet.
The SmartMIPS ASE specifies how Read Inhibit (RI) and eXecute Inhibit
(XI) bits in the page tables work. The upper two bits of EntryLo{0,1}
are RI and XI when the feature is enabled in the PageGrain register.
SmartMIPS only covers 32-bit systems. Cavium Octeon+ extends this to
64-bit systems by continuing to place the RI and XI bits in the top of
EntryLo even when EntryLo is 64-bits wide.
Because we need to carry the RI and XI bits in the PTE, the layout of
the PTE is changed. There is a two instruction overhead in the TLB
refill hot path to get the EntryLo bits into the proper position.
Also the TLB load exception has to probe the TLB to check if RI or XI
caused the exception.
Also of note is that the layout of the PTE bits is done at compile and
runtime rather than statically. In the 32-bit case this allows for
the same number of PFN bits as before the patch as the _PAGE_HUGE is
not supported in 32-bit kernels (we have _PAGE_NO_EXEC and
_PAGE_NO_READ instead of _PAGE_READ and _PAGE_HUGE).
The patch is tested on Cavium Octeon+, but should also work on 32-bit
systems with the Smart-MIPS ASE.
Signed-off-by: David Daney <ddaney@caviumnetworks.com>
To: linux-mips@linux-mips.org
Patchwork: http://patchwork.linux-mips.org/patch/952/
Patchwork: http://patchwork.linux-mips.org/patch/956/
Patchwork: http://patchwork.linux-mips.org/patch/962/
Signed-off-by: Ralf Baechle <ralf@linux-mips.org>
The soon to follow Read Inhibit/eXecute Inhibit patch needs TLBR and
ROTR support in uasm. We also add a UASM_i_ROTR macro.
Signed-off-by: David Daney <ddaney@caviumnetworks.com>
To: linux-mips@linux-mips.org
Patchwork: http://patchwork.linux-mips.org/patch/953/
Signed-off-by: Ralf Baechle <ralf@linux-mips.org>
64-bit CPUs have 64-bit c0_entrylo{0,1} registers. We should use the
64-bit dmtc0 instruction to set them. This becomes important if we
want to set the RI and XI bits present in some processors.
Signed-off-by: David Daney <ddaney@caviumnetworks.com>
To: linux-mips@linux-mips.org
Patchwork: http://patchwork.linux-mips.org/patch/954/
Signed-off-by: Ralf Baechle <ralf@linux-mips.org>
This patch adds a new DEBUG_ZBOOT option to allow the users to enable it
to debug the compressed kernel support for a new board and this optoin
should be disabled to reduce the kernel image size and speed up the
kernel booting procedure when the compressed kernel support is stable.
Signed-off-by: Wu Zhangjin <wuzhangjin@gmail.com>
To: Ralf Baechle <ralf@linux-mips.org>
Cc: Manuel Lauss <manuel.lauss@googlemail.com>
Cc: linux-mips@linux-mips.org
Patchwork: http://patchwork.linux-mips.org/patch/918/
Signed-off-by: Ralf Baechle <ralf@linux-mips.org>
The function is #if 0ed out. There are no other occurrences of its
name in the tree. It is safe to remove.
Signed-off-by: David Daney <ddaney@caviumnetworks.com>
To: linux-mips@linux-mips.org
Patchwork: http://patchwork.linux-mips.org/patch/936/
Signed-off-by: Ralf Baechle <ralf@linux-mips.org>
It is not always used, even if it is available.
Signed-off-by: Yoichi Yuasa <yuasa@linux-mips.org>
Cc: linux-mips <linux-mips@linux-mips.org>
Patchwork: http://patchwork.linux-mips.org/patch/933/
Acked-by: Atsushi Nemoto <anemo@mba.ocn.ne.jp>
Signed-off-by: Ralf Baechle <ralf@linux-mips.org>
[Ralf: Fixed up the rejects and changed all the new printk(KERN_...); to
pr_xxx() as suggested by Wu.]
Signed-off-by: Alexander Clouter <alex@digriz.org.uk>
To: linux-mips@linux-mips.org
Patchwork: http://patchwork.linux-mips.org/patch/920/
Signed-off-by: Ralf Baechle <ralf@linux-mips.org>
